Forum Thread: How to exclude partitions and/or directories from scan?

You are currently viewing a forum thread in the Secunia Community Forum. Please note that opinions expressed here are not of Secunia but solely reflect those of the user who wrote it.

This thread was submitted in the following forum:
OSI

This thread has been marked as locked.
vonTronje How to exclude partitions and/or directories from scan?
Member 26th Jan, 2009 14:14
Ranking: 0
Posts: 2
User Since: 25th Jan, 2009
System Score: N/A
Location: N/A
I'd like to exclude certain paths or directories from the scan, because they have older data and program backups in them.

How can I set this in Secunia PSI?

Thanks in advance,

Norbert

This user no longer exists RE: How to exclude partitions and/or directories from scan?
Secunia Official 26th Jan, 2009 14:27
Last edited on 26th Jan, 2009 14:29 Hi Norbert

Go to the Advanced interface, and go to the Settings tab.

Click on "Create ignore rule", you should get a pop-up.

Give the rule a name: like "backup". Enter the path of the folder you want to exclude from the scan.

Hover the cursor over the [?] to get some help with it

Good day

Morten Hansen
vonTronje RE: How to exclude partitions and/or directories from scan?
Member 26th Jan, 2009 15:27
Score: 0
Posts: 2
User Since: 25th Jan 2009
System Score: N/A
Location: N/A
Thank you, Morten,

for your fast and very helpful response. :-)

Regards,

Norbert
Was this reply relevant?
+0
-0

This thread has been marked as locked.