Forum Thread: PSI 3.24 hangs at "updating scanning results"

You are currently viewing a forum thread in the Secunia Community Forum. Please note that opinions expressed here are not of Secunia but solely reflect those of the user who wrote it.

This thread was submitted in the following forum:
PSI

This thread has been marked as locked.
MSendim PSI 3.24 hangs at "updating scanning results"
Member 26th Oct, 2012 19:29
Ranking: 0
Posts: 1
User Since: 26th Oct, 2012
System Score: N/A
Location: PT
Last edited on 26th Oct, 2012 19:30

Hi,

I've just updated PSI to v3.24. It seems to run quite well until the green bar gets 1mm away from finishing the "updating scanning results" phase.

My Toshiba Satellite runs on Windows 7 SP1.

Access through the McAfee firewall is set to "Total".

I'm currently forced to use a proxy, but during the update process PSI detected the correct configs and everything went on smoothly until the above mentioned point.

Any help, please?

MSendim

This user no longer exists RE: PSI 3.24 hangs at "updating scanning results"
Secunia Official 29th Oct, 2012 10:07

This thread has been marked as locked.