|ronhovde||Switching from Simple to Advanced interface mode|
|12th Mar, 2010 16:30|
User Since: 27th Mar, 2009
System Score: N/A
|If I switch from simple to advanced interface mode but then find that the advanced mode is too advanced for me, can I switch back to the simple mode?|
|Anthony Wells||RE: Switching from Simple to Advanced interface mode|
|12th Mar, 2010 16:38|
User Since: 19th Dec 2007
System Score: N/A
Last edited on 12th Mar, 2010 16:44
|Hello ronhovde ,
Just click the "simple" link at the top right of any PSI page . You can come back to "advanced" by clicking on that link , ust next to it . Resetting may take a moment or two .
It would be a shame not to try the "advanced" mode ; so here are some tips for "looking around" :-
Click on each/all the tabs and there is plenty of written advice about what each tab contains .
If a "problem" shows in the "insecure" or "end of life" tabs , then to help resolve any problem , here are some instructions to help you first of all get the best out of PSI :-
1)use PSI in "advanced" mode ;
2)in the "settings" tab make sure that the box in the first/upper section is NOT ticked in order to have the maximum info available ;
3)tell us in which "tab(s)" your problem programme is located ;
4)in that tab , click on the + in the box at the left end of the programme , the page will expand ;
5)in the expanded page , tell us what is written in the "installation path" ;
6)in the "toolbox" section , lower down , the link "technical details" should confirm the installation path details ;
7)click on the link "open folder" and you will see more details concerning the location of the "problem" .
Posting these details will help the Forum help you , if/when you have a problem .
It always seems impossible until its done.
|This user no longer exists||RE: Switching from Simple to Advanced interface mode|
|12th Mar, 2010 20:13|
|Stick with Advanced mode ronhovde
It takes a while to get used to it but it shows a lot of information.
If you go back to Simple it enables the Easy-to-Patch feature that limits the scan results.