Forum Thread: PSI UI incomplete on Win2K SP4?

You are currently viewing a forum thread in the Secunia Community Forum. Please note that opinions expressed here are not of Secunia but solely reflect those of the user who wrote it.

This thread was submitted in the following forum:
PSI

This thread has been marked as locked.
lexein PSI UI incomplete on Win2K SP4?
Member 9th Sep, 2010 08:06
Ranking: 0
Posts: 8
User Since: 8th Jul, 2009
System Score: N/A
Location: N/A
The UI for PSI 1.5.0.2 does not seem complete when running on Win2kSP4. It won't visually switch to Advanced mode, though the Advanced link becomes highlighted as if it did switch. After a scan (in either "mode"), the results fields are not filled out.

Screenshot showing system status: http://bayimg.com/aAoJbAaCn
and showing UI after scan: http://bayimg.com/AAoJfAacN

This particular system has 256M, and has been perking along just fine for years.
The PSI System Requirements don't mention a memory requirement.

This user no longer exists RE: PSI UI incomplete on Win2K SP4?
Member 9th Sep, 2010 09:51
Hi,

The PSI is expected to work as usual on Windows 2000 SP4.
Do your settings in Internet Explorer match those described in this FAQ item?
http://secunia.com/vulnerability_scanning/personal...

If so, please try to reload the interface, by right-clicking the PSI tray icon and selecting "Reload Interface".

Hope this helps.
Was this reply relevant?
+0
-0
lexein RE: PSI UI incomplete on Win2K SP4?
Member 9th Sep, 2010 15:35
Score: 0
Posts: 8
User Since: 8th Jul 2009
System Score: N/A
Location: N/A
Adding the domains to the IE trusted sites list does appear to have resulted in a correct display. In the interest of streamlining this in future I would suggest:
- Display a sensible error message to users with "trusted sites" set incorrectly, "Secunia unreachable: check IE Security Trusted Sites" rather than displaying nothing.
- Link this particular FAQ section as an asterisked item adjacent to "Windows 2000" on the System Requirements page.

Was this reply relevant?
+0
-0
This user no longer exists RE: PSI UI incomplete on Win2K SP4?
Member 9th Sep, 2010 15:45
Hi,

If this had been a recurring issue, I can assure you we would have. However, since you are the first/only user to report this particular issue, it doesn't seem quite necessary.

Either way, glad to hear everything's working properly.
Was this reply relevant?
+0
-0

This thread has been marked as locked.