Forum Thread: Update scan results

You are currently viewing a forum thread in the Secunia Community Forum. Please note that opinions expressed here are not of Secunia but solely reflect those of the user who wrote it.

This thread was submitted in the following forum:
PSI 2.0 Beta

This thread has been marked as locked.
leblancj Update scan results
Member 10th Nov, 2010 16:36
Ranking: 0
Posts: 2
User Since: 18th Dec, 2008
System Score: N/A
Location: N/A

could the scan results page could be updated as soon as one installed the solution for a particular product? This is helpful when one is updating several products and can't remember what has already been done.

Anthony Wells RE: Update scan results
Expert Contributor 10th Nov, 2010 17:57
Score: 2541
Posts: 3,402
User Since: 19th Dec 2007
System Score: N/A
Location: N/A
Last edited on 10th Nov, 2010 17:59
Hello again ,

This does happen for certain/many/not all products and is a major improvement in the Beta .

You probably need to enable "Program Monitoring" ->Dashboard->Configuration->Settings in order to have the benefit . See section 4.5 of the Secunia PSI Manual (PDF) which I have mentioned in your other thread .

Take care



It always seems impossible until its done.
Nelson Mandela
Was this reply relevant?

This thread has been marked as locked.